|
[Sponsors] |
[mesh manipulation] extrudeMesh: Wedge extrusion with positive AND negative angle |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 27, 2013, 09:14 |
extrudeMesh: Wedge extrusion with positive AND negative angle
|
#1 |
Senior Member
Francois Beaubert
Join Date: Mar 2009
Location: Lille, France
Posts: 147
Rep Power: 17 |
Hi Foamers,
I would like to know if it's possible to use the wedge extrusion of the extrudeMesh utility with at the same time positive and negative angle value. For example a symmetric wedge extrusion between -\theta,\theta would just be fine . Is there some hidden option to control this in the extrudeMeshDict ? Of course it's possible to split this in two operations but I've already got quite a lot of sub-domains that I have to stitch with stitchMesh utility and would like to avoid to use stitchMesh too much. Does anyone know if it's possible to do this kind of wedge extrusion ? Thank's for your helpful contributions Happy Foaming Francois |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Positive or negative values of Lambda2 for vortex structure visualization? | vidyadhar | OpenFOAM Running, Solving & CFD | 3 | November 27, 2019 08:03 |
Inlet and outlet profile are partially positive and negative at the same time | Loekatoni | OpenFOAM Pre-Processing | 0 | January 18, 2019 05:11 |
separate positive and negative forces on surface | xava | Main CFD Forum | 3 | December 5, 2017 11:32 |
Why air’s torque is negative and water’s torque is positive? | Jackzm | CFX | 3 | December 16, 2015 16:27 |
Positive Pressure ang negative Pressure | moca | CFX | 3 | September 18, 2010 06:00 |