 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] snappyHexMesh doesn't do feature edge snapping |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 2, 2014, 06:29
|
snappyHexMesh doesn't do feature edge snapping
|
#1 |
|
Senior Member
Yuehan
Join Date: Nov 2012
Posts: 142
Rep Power: 15  |
Hell Foamers,
According to http://www.openfoam.org/version2.2.0/snappyHexMesh.php , OF V2.2.0 and later version should be able to do the feature edge snapping as presented in the official webpage. However, in my case, snappyHexMesh doesn't snap feature edge. Take a look at the small circular hole, please. The red lines are the eMesh file containing feature edges. I don't know why it doesn't give the same behaviour as OF official webpage says. Any comments are welcome. |
|
|
|
|
|
May 7, 2014, 17:47
|
|
#2 |
|
Senior Member
Artur
Join Date: May 2013
Location: Southampton, UK
Posts: 372
Rep Power: 21 |
Hi,
It may be just me but your mesh seems undeformed at all. Are you sure that snapping was executed properly for your case? Peace, A |
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
| [snappyHexMesh] snappyHexMesh: Feature snapping of thin membrane edge | gooofy | OpenFOAM Meshing & Mesh Conversion | 7 | September 19, 2016 05:29 |
| [snappyHexMesh] SHM: feature edge snapping not conforming | thab | OpenFOAM Meshing & Mesh Conversion | 3 | November 26, 2012 15:04 |
| [snappyHexMesh] Understanding feature edge refinement and snapping | Horus | OpenFOAM Meshing & Mesh Conversion | 1 | May 31, 2012 13:08 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
Linear Mode
