 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] Is it possible to create .stl files faces in SolidWorks? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 4, 2015, 23:11
|
Is it possible to create .stl files faces in SolidWorks?
|
#1 |
|
New Member
Maurício Guilherme Alves dos Reis
Join Date: Feb 2015
Posts: 10
Rep Power: 12  |
Hello. I'm trying to generate a mesh using snappyHexMesh from a .stl file Constructed in SolidWorks program. However, it needs different boundary conditions on the geometry. For this need to generate .stl files of the total volume, and one for each type of geometry border. Is it possible to create .stl files faces in SolidWorks?
|
|
|
|
|
|
October 5, 2015, 08:41
|
|
#2 |
|
Senior Member
|
||
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Decomposing meshes | Tobi | OpenFOAM Pre-Processing | 22 | February 24, 2023 10:23 |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 08:34 |
| [snappyHexMesh] Layers not growing at all | zonda | OpenFOAM Meshing & Mesh Conversion | 12 | June 6, 2020 12:28 |
| [snappyHexMesh] Error snappyhexmesh - Multiple outside loops | avinashjagdale | OpenFOAM Meshing & Mesh Conversion | 53 | March 8, 2019 10:42 |
| [snappyHexMesh] SHM is not extruding/adding Layers everywhere | matthiasd | OpenFOAM Meshing & Mesh Conversion | 2 | October 16, 2016 17:45 |
Linear Mode
