|December 4, 2015, 02:23||
Adding Layer Problem
Join Date: Nov 2015
Posts: 6Rep Power: 3
I am beginner for openFoam. I try to generate mesh on snappyHexMesh for a hull geometry. Actually i was successful for generating a mesh. However, i couldn't add layer that i want for boundary layer.
Could you help me? My snappyHexMeshDict file and snapshot of my mesh is here.
Screenshot from 2015-12-04 08:03:11.jpg
|addlayers, addlayerscontrols, openfoam, snappy hex mesh|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Prismatic boundary layer||KateEisenhower||enGrid||5||September 15, 2015 07:48|
|snappyHexMesh Boundary Layer at Corner||panpanzhong||OpenFOAM Native Meshers: snappyHexMesh and Others||4||October 27, 2014 05:31|
|SnappyHexMesh: Layer on corners||Pj.||OpenFOAM Native Meshers: snappyHexMesh and Others||9||July 17, 2014 04:26|
|Problem with snappyHexMesh||samiam1000||OpenFOAM||2||December 13, 2012 09:41|
|Effect of adding layers with sHM||Nucleophobe||OpenFOAM Native Meshers: snappyHexMesh and Others||4||August 20, 2012 16:45|