[vignesh_sr]

Hello everyone,


I've just started using OpenFOAM, and I have a seemingly basic doubt with which I've been struggling for a bit now.

I'm simulating flow in a CD Nozzle. The nozzle is considered as axisymmetric, and I have created a basic mesh for one half of the nozzle in blockMesh. My question is, where do I specify my symmetry boundary condition? I've already specified that my lower wall is a symmetryPlane as shown below.



lowerWall
{
type symmetryPlane;
faces
(
(0 2 8 6)
(2 4 10 8)
);
}


Is this correct? Do I have to specify symmetry boundary anywhere else? If so, where?


Thank You