Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[Gmsh] axis not coming in boundary file of polymesh

Mark Forums Read

Reply

Search this Thread

September 22, 2016, 05:20	axis not coming in boundary file of polymesh	#1
vishal_s Member vishal Join Date: Mar 2013 Posts: 73 Rep Power: 13	Hello, I made a geometry in gmsh but after converting it for OpenFOAM, the axis line is not showing in the boundary file of polymesh. Can any one suggest me something to rectify it. Thanks in advance, Vishal

Reply

Tags

boundary file., gmsh

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] swak4foam for OpenFOAM 4.0	mnikku	OpenFOAM Community Contributions	80	May 17, 2022 08:06
[foam-extend.org] problem when installing foam-extend-1.6	Thomas pan	OpenFOAM Installation	7	September 9, 2015 21:53
Question about heat transfer coefficient setting for CFX	Anna Tian	CFX	1	June 16, 2013 06:28
[swak4Foam] build problem swak4Foam OF 2.2.0	mcathela	OpenFOAM Community Contributions	14	April 23, 2013 13:59
DxFoam reader update	hjasak	OpenFOAM Post-Processing	69	April 24, 2008 01:24

All times are GMT -4. The time now is 00:04.