|
[Sponsors] |
[mesh manipulation] Mesh refinement based on previous results |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 27, 2016, 15:37 |
Mesh refinement based on previous results
|
#1 |
New Member
Join Date: May 2016
Posts: 25
Rep Power: 10 |
Hi
is there a way to refine a mesh from the results (like velocity or pressure gradient) obtained from a past simulation? (I'm not looking for AMR) Thanks! |
|
May 4, 2017, 20:09 |
|
#2 |
Senior Member
Thomas Oliveira
Join Date: Apr 2015
Posts: 114
Rep Power: 12 |
Hi,
I am looking for a way to do that too. My best guess up to the moment is that we should create one or more cellSets based on the values of a field, and then refine these cellSets using refineMesh or refineHexMesh. See this thread and this thread. I would be happy if someone could point out a more straightforward solution. Best wishes, Thomas |
|
July 3, 2017, 05:27 |
|
#3 | |
New Member
JD
Join Date: May 2017
Posts: 24
Rep Power: 9 |
Quote:
|
||
Tags |
gradient, mesh, refine mesh |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh running killed! | Mark JIN | OpenFOAM Meshing & Mesh Conversion | 7 | June 14, 2022 02:37 |
[snappyHexMesh] Bad/jagged mesh around intersection of two .stl bodies | MBttR | OpenFOAM Meshing & Mesh Conversion | 7 | October 14, 2016 04:57 |
[snappyHexMesh] sHM refinement away from surface | nholt | OpenFOAM Meshing & Mesh Conversion | 1 | June 14, 2016 15:36 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 07:20 |
Mesh Refinement | JY | Siemens | 7 | September 19, 2002 14:37 |