 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] Strange SnappyHexMesh behavior at the symmetry plane |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 3, 2017, 15:24
|
Strange SnappyHexMesh behavior at the symmetry plane
|
#1 |
|
Member
Jack
Join Date: Dec 2011
Posts: 94
Rep Power: 14  |
Dear foamers,
I am using SnappyHexMesh for a relatively simple case (symmetric geometry). I found a strange behavior that sometimes the mesh spacing suddenly becomes very small at the symmetry plane, even though the geometry is very smooth there (see the attached figure). Not sure how to avoid this. Any ideas? Thanks very much in advance! BTW: I tried to mesh the whole geometry (without the symmetry plane) and this issue is gone. But I really want to save 50% of CPU time using half geometry. Best regards, Jack |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gridding a JAXA Standard Model Symmetry Plane | kagoc8 | Pointwise & Gridgen | 1 | January 3, 2019 12:18 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |
| symmetry plane | tommy | CFX | 10 | February 24, 2006 04:21 |
| Symmetry Plane | StudentAndrew | CFX | 1 | November 1, 2005 08:54 |
| Symmetry Plane boundary conditions | Tudor Miron | CFX | 1 | March 17, 2004 00:12 |
3Likes
Threaded Mode
