 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] splitMeshRegions does not split one cellZone after snappyHexMesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 8, 2018, 12:06
|
splitMeshRegions does not split one cellZone after snappyHexMesh
|
#1 |
|
New Member
Sarah
Join Date: Dec 2015
Posts: 2
Rep Power: 0  |
Hi all,
Based on the snappyMultiRegionHeater example, I am meshing a similar case with 3 domains using snappyHexMesh. I generated the STL files from ImageJ (as shown in the first image). snappyHexMesh refines the mesh at the interfaces (as shown in the second image) but splitMeshRegions -cellZones -overwrite does not separate the three regions (as shown in the third image). When I checked the constant/polyMesh/cellZones after snappyHexMesh, one of the regions had only 1 element which was not expected, I am not sure why. Any ideas? Your help would be heartfully appreciated. Cheers, Sarah |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] 2D adaptive Mesh Refinement | baco | OpenFOAM Community Contributions | 80 | August 14, 2022 14:18 |
| [snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell | Arman_N | OpenFOAM Meshing & Mesh Conversion | 1 | May 20, 2019 17:16 |
| Problem of creating only cellZone (no faceZone) using snappyHexMesh | wc34071209 | OpenFOAM Pre-Processing | 5 | November 16, 2015 20:58 |
| [snappyHexMesh] snappyHexMesh matches wrong cells to CellZone | Siegunn | OpenFOAM Meshing & Mesh Conversion | 4 | July 31, 2015 05:10 |
| [snappyHexMesh] MultiRegionMeshing with SnappyHexMesh - SplitMeshRegions doesnt pickup my surfaces | Kenneth J. | OpenFOAM Meshing & Mesh Conversion | 0 | January 30, 2015 10:07 |
Linear Mode
