 |
 |
 |
|
|
|
[Sponsors] | ||||
[mesh manipulation] Extract mesh from 3d to 2d in OpenFOAM |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 9, 2017, 09:45
|
Extract mesh from 3d to 2d in OpenFOAM
|
#1 |
|
New Member
Ahmet
Join Date: Mar 2011
Posts: 10
Rep Power: 16  |
Hello everyone,
I have a strange problem. I made a 3D mesh with a non-conformal commercial package and exported in conformity with OpenFOAM mesh. The mesh is not isotropic. In order to show 3-D effect, I want to get slice which places with corresponding to mid-point in z axis and create a new 2-D mesh. Do you know a utility that will solve this problem? I think this is the opposite of extrudeMesh. I am open to any kind of utility/program that will achieve this. Thank you in advance, |
|
|
|
|
|
| Tags |
| 3-d, extrudemesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Getting Started with OpenFOAM | wyldckat | OpenFOAM | 26 | June 21, 2024 07:54 |
| Map of the OpenFOAM Forum - Understanding where to post your questions! | wyldckat | OpenFOAM | 10 | September 2, 2021 06:29 |
| [Commercial meshers] About the Commercial and Closed Source Meshers discussed here | wyldckat | OpenFOAM Meshing & Mesh Conversion | 3 | July 22, 2020 23:09 |
| [Commercial meshers] OpenFoam Mesh to Fluent Mesh in parallel case | DominicTNC | OpenFOAM Meshing & Mesh Conversion | 3 | November 22, 2017 10:19 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |
Linear Mode
