 |
 |
 |
|
|
|
[Sponsors] | ||||
[mesh manipulation] Removal of specific cells |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 9, 2018, 19:30
|
Removal of specific cells
|
#1 |
|
Member
Join Date: Dec 2012
Posts: 33
Rep Power: 13  |
Hi,
I have imported a structured 2D grid with hex cells into OF (1 cell thick in 3rd direction). I want to remove some cells from the grid to create flat plate that would act as a wall in the domain. There's topoSet, createBaffles and other ways too but I'm unsure of the approach to take here. Any suggestions to the best way to do this? I do not have any patches defining the plate but know which cells are to be removed. Thanks! |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
| [snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 03:21 |
| [ICEM] Problem with prism cells | sidharath | ANSYS Meshing & Geometry | 0 | September 1, 2015 07:09 |
| [snappyHexMesh] snappyHexMesh Segmentation Fault | avd28 | OpenFOAM Meshing & Mesh Conversion | 11 | May 11, 2015 20:32 |
| physical boundary error!! | kris | Siemens | 2 | August 3, 2005 00:32 |
Linear Mode
