[snappyHexMesh] not symmetric mesh around symmetric geometry

Aeronautics El. K. · March 4, 2015, 13:03

Hello all.

I'm trying to mesh an airplane which is obviously symmetrical along the centreline.

I've tried quite a few different things:
a. take the whole aircraft and have blockMesh chop-off the right half of the airplane
b. take the whole aircraft and have blockMesh chop-off the left half of the airplane
c. mesh the whole airplane as it is

I'm running snappyHexMesh in parallel.

In every single case that I've tried, the right and left part of the mesh are not symmetric as one would expect. This is especially surprising in the case of the full aircraft.
The problem is around the trailing edges which get better resolved on one side of the aircraft but not on the other (or either the left-mesh or the right-mesh).
Explicit or implicit feature extract doesn't seem to have any effect.

Does anyone have any idea why this might be happening?

ps
I'm currently running another case with exactly the same case but on one processor to see if that makes any difference.

GrivalszkiP · May 23, 2020, 02:51

Hi!

Have you solved the problem? If yes, how?

March 4, 2015, 13:03	not symmetric mesh around symmetric geometry	#1
Aeronautics El. K. Senior Member Lefteris Join Date: Oct 2011 Location: UK Posts: 337 Rep Power: 15	Hello all. I'm trying to mesh an airplane which is obviously symmetrical along the centreline. I've tried quite a few different things: a. take the whole aircraft and have blockMesh chop-off the right half of the airplane b. take the whole aircraft and have blockMesh chop-off the left half of the airplane c. mesh the whole airplane as it is I'm running snappyHexMesh in parallel. In every single case that I've tried, the right and left part of the mesh are not symmetric as one would expect. This is especially surprising in the case of the full aircraft. The problem is around the trailing edges which get better resolved on one side of the aircraft but not on the other (or either the left-mesh or the right-mesh). Explicit or implicit feature extract doesn't seem to have any effect. Does anyone have any idea why this might be happening? ps I'm currently running another case with exactly the same case but on one processor to see if that makes any difference. __________________ Lefteris

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[snappyHexMesh] snappyHexMesh does not create any mesh except one for the reference cell	Arman_N	OpenFOAM Meshing & Mesh Conversion	1	May 20, 2019 17:16
[snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water!	divergence	OpenFOAM Meshing & Mesh Conversion	0	January 23, 2019 04:17
[ICEM] Problems with structured mesh in IcemCFD symmetric problem	jexposito	ANSYS Meshing & Geometry	3	December 19, 2015 05:34
unstructured vs. structured grids	Frank Muldoon	Main CFD Forum	1	January 5, 1999 10:09

May 23, 2020, 02:51		#2
GrivalszkiP Member Grivalszki Péter Join Date: Mar 2019 Location: Budapest, Hungary Posts: 39 Rep Power: 7	Hi! Have you solved the problem? If yes, how?