 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] STL file for snappyHexMesh |
9Likes
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 28, 2020, 17:14
|
STL file for snappyHexMesh
|
#1 |
|
Member
Tommaso M.
Join Date: Sep 2018
Location: Milan, Italy
Posts: 67
Rep Power: 7  |
Hi All,
I need to create a mesh by using snappyHexMesh. I create the CAD file as an assembly and convert it into an STL. When I open such STL file it contains only a single "solid", while it should be composed by two solids, i.e. wall and cylinder. In this way I cannot distinguish them as different patches while making the mesh. Does anyone know how to generate an STL file (from CAD) which contains the parts as different solids and not as a single object? Best, Tommy |
|
|
|
|
| Tags |
| cad, snappy, stl |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using PengRobinsonGas EoS with sprayFoam | Jabo | OpenFOAM Running, Solving & CFD | 35 | April 29, 2022 15:35 |
| how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 08:46 |
| what is swap4foam ?? | AB08 | OpenFOAM | 28 | February 2, 2016 01:22 |
| [Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0 | Seroga | OpenFOAM Community Contributions | 9 | June 12, 2015 17:18 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
Threaded Mode
