|
[Sponsors] |
[snappyHexMesh] The overwrite option is not working |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 9, 2020, 04:37 |
The overwrite option is not working
|
#1 |
New Member
Saverio
Join Date: Oct 2020
Posts: 5
Rep Power: 5 |
Hi! I have a very basic question about snappyHexMesh.
I am using OpenFOAM v1912 and I run the command "snappyHexMesh -overwrite 2>&1 | tee log.snappyHexMesh", because I want to overwrite all the mesh files. The problem is that this does not work at all. At the end of the meshing process, I have all the files generated by snappyHexMesh. And this is a big problem for me because If I try to run the FoamToVTK, the checkMesh or the PatchSummary command, they work on all the files and it is very time consuming. Do you have any idea? |
|
October 14, 2020, 03:59 |
|
#2 |
New Member
Saverio
Join Date: Oct 2020
Posts: 5
Rep Power: 5 |
Well, if someone has the same problem, I found the error in my case. I basically set the mesh debug option equal to 1 in the snappyHexMeshDict file.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 60 | July 17, 2024 05:45 |
Centrifugal fan | j0hnny | CFX | 13 | October 1, 2019 13:55 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
error message | cuteapathy | CFX | 14 | March 20, 2012 06:45 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |