Home > Forums > Software User Forums > OpenFOAM > OpenFOAM Meshing & Mesh Conversion

[Salome] best option for meshing for chtMultiRegion?

Mark Forums Read

Reply

Search this Thread

March 30, 2021, 08:27	best option for meshing for chtMultiRegion?	#1
Clau.77 Member Claudia Join Date: Mar 2021 Posts: 43 Rep Power: 6	Hi! I want to create a geometry that is surrounded by air. The geometry is basically a tray that is filled with a solid substance. So i have two solid geometries and one fluid. My question is: what is the best way to create the mesh for this? I like salome but there are so many different options: matlab, snappyhexmesh, salome,... i don t know what to use. Does anyone have experience with Meshing for chtMultiRegionFoam?

Reply

Tags

chtmultiregionfoam, mesh, multiregion meshing, openfoam, snappy hex mesh

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 01:58
Multiphase flow - incorrect velocity on inlet	Mike_Tom	CFX	6	September 29, 2016 02:27
Simple piston movement in cylinder- fluid models	arun1994	CFX	4	July 8, 2016 03:54
Compression stoke is giving higher pressure than calculated	nickjuana	CFX	62	May 19, 2015 14:32
RPM in Wind Turbine	Pankaj	CFX	9	November 23, 2009 05:05

All times are GMT -4. The time now is 13:31.