|
[Sponsors] |
[snappyHexMesh] Error in the construction of boundary layers |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 7, 2021, 05:20 |
Error in the construction of boundary layers
|
#1 |
New Member
Dmitry
Join Date: Sep 2018
Posts: 12
Rep Power: 7 |
Hello everyone!
There was an error in drawing boundary layers. I set the parameters as indicated below, but the boundary layers are not drawn. The complete log from snappyHexMesh and the file itself are shown below. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Boundary layers on complex curves with good tetQuality | MikeWorth | OpenFOAM Meshing & Mesh Conversion | 0 | August 4, 2020 07:03 |
Multiphase flow - incorrect velocity on inlet | Mike_Tom | CFX | 6 | September 29, 2016 01:27 |
Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 05:15 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |