[mesh manipulation] Optimize repeating mesh

gustavoliveira · April 2, 2023, 09:03

Hello,

I need to simulate the flow of water over the attached spillway. The pattern on the inside repeats 12 times, but the borders are slightly different. Is there a way to optimize this mesh? Avoiding simulating some of the internal patterns.

Thanks.

Alczem · April 3, 2023, 03:58

Hello,

I think you can use periodic boundary conditions (or cyclic, for OpenFoam). Look for tutorials about channel simulations. Basically, your inlet conditions will be mapped according to what your outlet will "see", so you only need to mesh one spatial period of your domain.

Good luck

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
[snappyHexMesh] High quality mesh for wind in complex urban environment	ziboaa	OpenFOAM Meshing & Mesh Conversion	1	January 12, 2021 15:33
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters)	shubham jain	ANSYS Meshing & Geometry	1	April 10, 2017 05:03
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11

April 3, 2023, 03:58		#2
Alczem Senior Member Join Date: Dec 2021 Posts: 209 Rep Power: 5	Hello, I think you can use periodic boundary conditions (or cyclic, for OpenFoam). Look for tutorials about channel simulations. Basically, your inlet conditions will be mapped according to what your outlet will "see", so you only need to mesh one spatial period of your domain. Good luck