 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] the mesh will be distorted a lot while moving object |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 15, 2022, 01:41
|
the mesh will be distorted a lot while moving object
|
#1 |
|
Senior Member
kimy
Join Date: Mar 2019
Location: https://t.me/pump_upp
Posts: 164
Rep Power: 7     |
Hi guys,
I hope who can give me some suggestions regarding the moving NACA0012 with a wavy function motion. As you can see from the attached figure, the grid behind the tail was distorted to a large extent, which results in simulation collapsing. I really don't know how to generate a suitable mesh that can be used for such situation. I also tried the snappyHexMesh, but I always encountered the same problem. Thanks in advance. |
|
|
|
|
|
November 18, 2022, 07:33
|
|
#2 |
|
Senior Member
kimy
Join Date: Mar 2019
Location: https://t.me/pump_upp
Posts: 164
Rep Power: 7 |
anybody can provide some suggestions?
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh/splitMeshRegion : region1 in zone "-1" | GuiMagyar | OpenFOAM Meshing & Mesh Conversion | 3 | August 4, 2023 12:38 |
| [snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
| [mesh manipulation] CreateBaffles generates distorted mesh | Andrea_85 | OpenFOAM Meshing & Mesh Conversion | 0 | May 24, 2019 04:36 |
| Gambit problems | Althea | FLUENT | 22 | January 4, 2017 03:19 |
| How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 09:38 |
Linear Mode
