|
[Sponsors] |
April 13, 2006, 15:59 |
BlockMesh error
|
#1 |
Senior Member
Hrvoje Jasak
Join Date: Mar 2009
Location: London, England
Posts: 1,905
Rep Power: 33 |
So far, you've got a bunch of points, but only one block:
hex (0 1 2 3 4 5 6 7) (50 50 1) simpleGrading (1 1 1) Since the block only uses points 0-7, it is clear that face 4(0 16 17 3) does not have a block it belongs to, which is as error. Which part of the error message don't you understand? Hrv
__________________
Hrvoje Jasak Providing commercial FOAM/OpenFOAM and CFD Consulting: http://wikki.co.uk |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 09:00 |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
[swak4Foam] groovyBC: problems compiling: "flex: not found" and "undefined reference to ..." | sega | OpenFOAM Community Contributions | 12 | February 17, 2010 09:30 |
Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
Problem with compile the setParabolicInlet | ivanyao | OpenFOAM Running, Solving & CFD | 6 | September 5, 2008 20:50 |