|
[Sponsors] |
[blockMesh] 90 degrees pipe bend - changing shape midway |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 20, 2010, 11:25 |
90 degrees pipe bend - changing shape midway
|
#1 |
Senior Member
Join Date: Mar 2009
Location: Norway
Posts: 137
Rep Power: 17 |
Dear foamers,
I have created a bend in blockMesh using the O-grid technique (squared center section). However, when investigating the 3D geometry in paraView, the mid pipe profile (45 degrees) of the bend is not quite circular. I have looked over the arc section in blockMeshDict over and over again, but I cannot find any obvious errors. It this how it is supposed to be, or should I file a bug report? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
need help about double pipe heat exchanger with chtMultiRegionSimpleFoam | wuyangzhen | OpenFOAM | 10 | December 12, 2017 00:19 |
[PyFoam] Problems with the new PyFoam release | zfaraday | OpenFOAM Community Contributions | 13 | December 9, 2014 18:58 |
[PyFoam] having problems with pyfoam Installation | vitorspadetoventurin | OpenFOAM Community Contributions | 3 | December 2, 2014 07:18 |
How to get "Fully developed flow" at pipe inlet without changing length | nihossain | FLUENT | 0 | November 2, 2011 16:22 |
changing Mesh with known new points for shape | kilerskill | OpenFOAM | 15 | February 16, 2011 03:21 |