|
[Sponsors] |
[Commercial meshers] Star4ToFoam boundary problems. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 8, 2010, 15:35 |
Star4ToFoam boundary problems.
|
#1 |
New Member
Gustavo
Join Date: Feb 2010
Location: Curitiba - PR - Brasil
Posts: 16
Rep Power: 16 |
Hi there,
I'm having a lot of problem trying to convert a StarCD mesh to OpenFoam. I've not figured out what is going on, but the issue is with the bnd file. My mesh is an engine cylinder geometry, and as the StarCD bnd file is the problem, I'd like to convert the mesh without it. My question is how can I patch the mesh latter on? I've tried the autoPatch, but it's quite a massive job because it's not an simple geometry. Does anyone know of a graphical interface or any other ideas on how can I overcome this painful task? Thanks in advance! Gustavo. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
Error - Solar absorber - Solar Thermal Radiation | MichaelK | CFX | 12 | September 1, 2016 05:15 |
Waterwheel shaped turbine inside a pipe simulation problem | mshahed91 | CFX | 3 | January 10, 2015 11:19 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |