 |
 |
 |
|
|
|
[Sponsors] | ||||
[snappyHexMesh] Ship hull using snappyHexMesh |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 27, 2010, 05:52
|
Ship hull using snappyHexMesh
|
#1 |
|
Senior Member
Emanuele
Join Date: Mar 2009
Posts: 110
Rep Power: 16  |
Hi, i made a mesh around a ship hull using snappyHexMesh. The "checkMesh" returns me a warning on 2 non-orthogonal faces (with checkMesh on 1.6 i had no warning). I started the simulation but it fails with a Floating point exception error. Have you any idea??
This is the case http://ubuntuone.com/p/E1i/ Regards Emanuele |
|
|
|
|
|
June 28, 2011, 10:45
|
|
#2 |
|
Senior Member
stephane sanchi
Join Date: Mar 2009
Posts: 314
Rep Power: 17 |
Is it possible to use this combination of applications for free surface calculation :
blockMesh refineMesh (only in Z-direction) snappyHexMesh When I launch sHM i get the following error message: --> FOAM FATAL ERROR: cell 72260 of level 0 uses more than 8 points of equal or lower level Points so far:8(74396 74397 74497 74498 79547 79548 79648 79649) Regards, Stephane |
|
|
|
|
|
|
| Tags |
| hull, mesh, ship, snappyhexmesh |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] SnappyHexMesh Ship Hull with Appendages Problem | bizzy | OpenFOAM Meshing & Mesh Conversion | 7 | December 14, 2017 16:22 |
| Ship hull with appendage as seperate patch runs into error | manoj_nav | OpenFOAM Running, Solving & CFD | 1 | March 13, 2016 09:12 |
| How to output the water resistance on a Ship hull | Sachin m | OpenFOAM Post-Processing | 1 | January 26, 2015 12:24 |
| Free surface comes above the hull of the ship | Sachin m | OpenFOAM Pre-Processing | 0 | September 4, 2014 00:08 |
| Error in meshing a Ship hull using snappyhexmesh | Sachin m | OpenFOAM Pre-Processing | 1 | August 27, 2014 23:27 |
Linear Mode
