|
[Sponsors] |
[snappyHexMesh] Irregular mesh generation for simple box geometry |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
March 7, 2011, 18:04 |
Irregular mesh generation for simple box geometry
|
#1 |
New Member
Andy Lowe
Join Date: Dec 2010
Posts: 10
Rep Power: 16 |
Hi, snappy mesh is a fantastic bit of kit - brilliant no less. I have a slight problem and I'm not sure what the fix is. If I generate a simple square box from stl surfaces and then generate a mesh, at the corners I end up with irregular refinement. What I mean by this specifically is that I expect to see the same mesh at each edge of the box. On some edges the mesh has a smooth refinement region capturing the corner and others there's a smooth refinement region but the refinement region is thinner. Sometimes significantly thinner. Considering this is a symmetric and regular geometry problem then I'd expect the same mesh refinement and approximation to the underlying geometry. Any idea what I could be doing wrong?
Many thanks in advance for any help Andy. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Gambit problems | Althea | FLUENT | 22 | January 4, 2017 04:19 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 19:57 |
[ANSYS Meshing] Meshing Strategy for inside geometry | powpow | ANSYS Meshing & Geometry | 6 | January 16, 2013 05:32 |
[ANSYS Meshing] Question about mesh generation learning | lnk | ANSYS Meshing & Geometry | 2 | July 7, 2012 07:45 |
unstructured vs. structured grids | Frank Muldoon | Main CFD Forum | 1 | January 5, 1999 11:09 |