|
[Sponsors] |
How to find the coordinate value for OF output results? (for matlab post-processing) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 2, 2013, 14:39 |
How to find the coordinate value for OF output results? (for matlab post-processing)
|
#1 |
Member
Jack
Join Date: Dec 2011
Posts: 94
Rep Power: 14 |
Hi all,
I want to do postprocessing using Matlab. I found that the OF output results for every steps is just the cell value, no cell location or any other information, so it is very hard to read the OF output into matlab (I have several blocks). I check the constat/polyMesh/points and I can only found the points x,y,z value, not the cell x,y,z. So my question is: how can I find the corresponding x,y,z for each cell value in the OF output results? Thanks in advance! Regards, |
|
September 3, 2013, 00:20 |
|
#2 | |
Senior Member
Nima Samkhaniani
Join Date: Sep 2009
Location: Tehran, Iran
Posts: 1,266
Blog Entries: 1
Rep Power: 24 |
well, it save cell center data, if you want to know cell center position for post processing then use
Quote:
__________________
My Personal Website (http://nimasamkhaniani.ir/) Telegram channel (https://t.me/cfd_foam) |
||
September 3, 2013, 12:31 |
|
#3 |
Member
Jack
Join Date: Dec 2011
Posts: 94
Rep Power: 14 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Errors running allwmake in OpenFOAM141dev with WM_COMPILE_OPTION%3ddebug | unoder | OpenFOAM Installation | 11 | January 30, 2008 20:30 |
Problems with repeating results | Lee | Siemens | 4 | May 26, 2006 03:39 |
Gambit journal : how to find a vertex coordinate ? | Cyril | FLUENT | 0 | April 21, 2006 04:38 |
Gambit TUI : how to find a vertex coordinate ? | Cyril | FLUENT | 0 | April 20, 2006 04:29 |
Gambit: Text command to find a vertex' coordinate? | Cyril | FLUENT | 0 | April 19, 2006 11:17 |