|
[Sponsors] |
September 7, 2014, 01:18 |
pressure in post-processing? which unit ?
|
#1 |
Member
Tommy Sp
Join Date: Jan 2014
Posts: 51
Rep Power: 12 |
in post-processing (ParaView), the pressure is given in which unit when using the units [0 2 -2 0 0 0 0] in "p" file? [Pa] or [mē/sē]?
Best Regards, Vitor Spadeto |
|
September 7, 2014, 07:22 |
|
#2 |
Member
Julian Langowski
Join Date: May 2011
Location: Bremen, Germany
Posts: 91
Rep Power: 15 |
Dear Vitor,
OpenFOAM uses density specific pressure for calculation: p* = p / rho Best regards Julian
__________________
πάντα ῥεῖ - Heraclitus |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
static vs. total pressure | auf dem feld | FLUENT | 17 | February 26, 2016 13:04 |
NO model vs post processing in coal combustion,CFX | sakalido | CFX | 1 | April 15, 2011 14:07 |
Neumann pressure BC and velocity field | Antech | Main CFD Forum | 0 | April 25, 2006 02:15 |
Gas pressure question | Dan Moskal | Main CFD Forum | 0 | October 24, 2002 22:02 |
Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 15:00 |