|
[Sponsors] |
Calculate a custom flux through the interface of a two phase flow |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 18, 2016, 19:41 |
Calculation of a custom flux through the interface of a two phase flow
|
#1 |
Member
Arsalan
Join Date: Jul 2014
Posts: 74
Rep Power: 11 |
Dear Foamers,
I'm simulating a typical two-phase flow by modified interFoam solver in OF 2.3.0, well the problem is i need to calculate a custom flux ( a kind of heat flux) through the interface of two phases as follows: where D is a transport property like rho that added to the solver, T is an added variable like temperature, is the volume fraction and is the normal to the interface. Well with these descriptions, how the flux F could be calculated through the interface during the simulation? Any help and comment will be greatly appreciated, Regards, Arsalan. Last edited by arsalan.dryi; October 19, 2016 at 13:18. |
|
Tags |
flux calculation, interface, interfoam, swak4foam, swakexpression |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Setting rotating frame of referece. | RPFigueiredo | CFX | 3 | October 28, 2014 04:59 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
mass flux in two phase flow | nimasam | OpenFOAM | 0 | December 9, 2010 03:48 |
compressible two phase flow in CFX4.4 | youngan | CFX | 0 | July 1, 2003 23:32 |