Visualizing the moving probes

arashgmn · August 7, 2020, 17:07

Dear community,

I have a rotating mesh with a set of probes over a rotating wall. I was wondering if there's a way to visualize the probe location in Paraview as the mesh rotates to ensure the correct configuration of probes.

Thanks for your help.
Arash

anais.M · August 8, 2023, 09:35

hello,
did you found a way to visualise your probes moving with the mesh in paraview?
Thank you

arashgmn · August 8, 2023, 10:01

Hi,
I asked this question quite some time ago and unfortunately all I can recall now is that I learned a few tricks by watching a few paraview tutorials on youtube. Hope the community provides more details.

Good luck and all the best,
Arash

anais.M · August 8, 2023, 10:08

Thank you so much for your replay and for the advice Arash, I'll do so!
best,
Anaïs

August 7, 2020, 17:07	Visualizing the moving probes	#1
arashgmn New Member Arash Join Date: May 2017 Posts: 17 Rep Power: 8	Dear community, I have a rotating mesh with a set of probes over a rotating wall. I was wondering if there's a way to visualize the probe location in Paraview as the mesh rotates to ensure the correct configuration of probes. Thanks for your help. Arash

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NO Moving Probes for Moving Mesh in Foam Extend 4.0	alia	OpenFOAM Running, Solving & CFD	6	June 25, 2018 09:24
Difference between Moving Wall and Moving Boundary	Finbar	FLUENT	1	January 12, 2018 09:06
[snappyHexMesh] jagged, ragged edges...	ziemowitzima	OpenFOAM Meshing & Mesh Conversion	138	July 23, 2012 23:41
[Other] How to set up a dynamic mesh for a piston moving through a tube of variable diameter?	karkar	OpenFOAM Meshing & Mesh Conversion	0	July 4, 2012 06:54
Moving mesh in Fluent	fivos	FLUENT	0	April 2, 2010 09:45

August 8, 2023, 09:35		#2
anais.M New Member Anais Messaoudi Join Date: May 2023 Posts: 3 Rep Power: 2	hello, did you found a way to visualise your probes moving with the mesh in paraview? Thank you

August 8, 2023, 10:01		#3
arashgmn New Member Arash Join Date: May 2017 Posts: 17 Rep Power: 8	Hi, I asked this question quite some time ago and unfortunately all I can recall now is that I learned a few tricks by watching a few paraview tutorials on youtube. Hope the community provides more details. Good luck and all the best, Arash

August 8, 2023, 10:08		#4
anais.M New Member Anais Messaoudi Join Date: May 2023 Posts: 3 Rep Power: 2	Thank you so much for your replay and for the advice Arash, I'll do so! best, Anaïs