|
[Sponsors] |
![]() |
![]() |
#1 |
Guest
Posts: n/a
|
Hello,
I'm an OpenFOAM beginner, so my problem is fairly simple, but wide: I need to save and analyze the gamma field on a boundary wall. I've found the ID of my patch (impactWall), so how can I initialize (and write to disk) a new new object containing only the mesh from the patch and the gamma scalar value? Which classes do methods boundaryMesh() and findPatchID() belong to? Where can I find the list of classes used mainly for postprocessing? I keep getting lost when I dig through code using Doxygen. Thanks in advance. |
|
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Morphology Divergence of a boundary patch field | ngj | OpenFOAM Running, Solving & CFD | 42 | June 3, 2015 09:46 |
Gamma field initialisation | mer | OpenFOAM Pre-Processing | 0 | March 1, 2008 08:12 |
Boundary condition vector field gradient from two sides of patch face | quba | OpenFOAM | 0 | December 12, 2007 05:26 |
How to patch a different gamma zone in the lesInterFoam | waynezw0618 | OpenFOAM Running, Solving & CFD | 0 | December 5, 2006 01:36 |
How to patch a different gamma zone in the lesInterFoam | waynezw0618 | OpenFOAM Running, Solving & CFD | 0 | December 5, 2006 01:33 |