 |
 |
 |
|
|
|
[Sponsors] | ||||
March 19, 2009, 12:08
|
dxFoamExec orphan process
|
#1 |
|
Super Moderator
Philip Cardiff
Join Date: Mar 2009
Location: Dublin, Ireland
Posts: 1,099
Rep Power: 34  |
Hi,
Everytime I close dxFoam, the process 'dxFoamExec' is left running and will use quite a considerable amount of cpu if it is not killed. If i open dxFoam again, then another dxFoamExec process will start. How do I stop get this annoying process to stop when i close dxFoam? Any suggestions are welcome, Thanks, Philip C. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to process results | pullaiah | Siemens | 3 | March 3, 2008 20:16 |
| parallel process | Jane | FLUENT | 1 | May 11, 2004 14:23 |
| Automate this process | Jamcam | FLUENT | 3 | January 29, 2004 12:42 |
| the process of CFX | beginer | CFX | 2 | November 7, 2001 11:39 |
| Fluidized bed process | Istadi | Main CFD Forum | 0 | June 21, 2001 06:43 |
Linear Mode
