|
[Sponsors] |
March 8, 2013, 20:24 |
cellSet bounded by STL surface
|
#1 | |
New Member
SV
Join Date: May 2009
Posts: 15
Rep Power: 17 |
I want to trim the cell set shown in the picture by the red STL file, i.e. I want to get rid of the hoop of cells that are outside the red boundary. The original cell set is a cylinder. I have tried:
Quote:
Anyone knows how to fix this? If surfaceToCell is the way to go, how are inside and outside regions defined? And I'm not quite sure about the last two parameters, even though I've played with them with no result. |
||
March 12, 2013, 11:43 |
|
#2 |
New Member
SV
Join Date: May 2009
Posts: 15
Rep Power: 17 |
For future reference, the STL needs to be closed.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Simulation of varying contact angles for a large droplet of water on a surface | cp703 | CFX | 5 | July 20, 2013 06:08 |
Comsol (4.3): convert parametric surface into block? | sgalaz | COMSOL | 0 | November 9, 2012 09:20 |
[snappyHexMesh] snappyHexMesh aborting | Tobi | OpenFOAM Meshing & Mesh Conversion | 0 | November 10, 2010 03:23 |
STL units and Surface elevation plot | MAB | FLOW-3D | 11 | May 9, 2010 15:55 |
free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |