|
[Sponsors] |
August 14, 2013, 13:35 |
renumberMesh and cyclic BC's
|
#1 |
Senior Member
Join Date: Mar 2010
Posts: 173
Rep Power: 17 |
Hi everyone,
i hope someone has some experience with the following: I have a rotationally cyclic mesh, which i import from from Fluent format, and use createPatch to recreate the cyclics etc. However, i have just discovered renumberMesh to reduce bandwidth, and so gave this a try - how, it seems to mess up the face numbering on the cyclic faces - and then i get a face area mismatch warning when i try to run the solver. Does anyone know how / if it is possible to use renumberMesh, without destroying the face numbering sequence on cyclic faces, or what i need to do to re-recreate the cyclic faces so they are correctly matched with their opposite faces? best regards jon |
|
Tags |
createpatch, cyclics, error, renumbermesh |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Can't couple front & back faces in cyclic BC after snapping in SHM | hakonbar | OpenFOAM Meshing & Mesh Conversion | 4 | December 8, 2013 16:50 |
[snappyHexMesh] Solution Snappy Hex 2D Msh with Surface Layers and cyclic bc for symmetric geometry | flexi182 | OpenFOAM Meshing & Mesh Conversion | 0 | May 24, 2013 08:38 |
cyclic BC - createPatch | AirS | OpenFOAM | 7 | November 12, 2009 10:04 |