|
[Sponsors] |
November 15, 2013, 06:28 |
Cyclic boundary in Multiregion case
|
#1 |
Member
MSarkar
Join Date: Dec 2009
Posts: 99
Rep Power: 16 |
Hi FOAMers, I need to specify cyclic BC in a multi-region case. where cycilc boundary and neighbourPatch belongs to two different regions. How to create this BC using OF-2.2.x? Geometry is simple, so I used blockMesh to create geometry and mesh and then used makeCellSets to create different zones. When I created the initial mesh, cyclic BC were there but after splitMeshRegions they are not present in the corresponding regions. What should I do or how to create cyclic BC for multiregion case where cyclic boundary neighbourPatch is present in another region? Geometry is attached here. one cyclic boundary is left side of green region and another boundary is right side of blue region.
Any help would be appreciated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
interFoam and cyclic boundary condition issue | General_Gee | OpenFOAM Running, Solving & CFD | 17 | October 8, 2018 09:33 |
Cyclic boundary conditions concerning channel with constant flow rate | pascool | OpenFOAM Pre-Processing | 1 | November 16, 2012 13:04 |
[Gmsh] Import problem | ARC | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2010 10:56 |
Adaptive Mesh Refinement and Cyclic Boundary Conditions | adona058 | OpenFOAM Running, Solving & CFD | 6 | October 23, 2009 09:17 |