setup ejector unit in helyx os -- CFD Online Discussion Forums

November 9, 2016, 15:15	setup ejector unit in helyx os	#1
of_beginner New Member Join Date: Oct 2016 Posts: 1 Rep Power: 0	Hello everyone, As my nick says I am an openfoam beginner. My first problem is how to setup ejector unit in helyx os correctly, here is the picture from the "air". I made for main Inlet total pressure (for example for 8bar, 801325/1.205=665000 m2/s2) and for the rest total pressure 0 and velocity type for all input pressure inlet outlet velocity, turbulence model - k- omega SST. Then I made analysis but the result are about (1/5)-(1/10) of real results. Any suggestions?

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Taylor Couette Setup and Boundary Conditions	DaSh	OpenFOAM Pre-Processing	2	September 28, 2017 12:02
2D Glass Melt Simulation Setup	marmz	FLUENT	5	October 9, 2016 15:25
[OpenFOAM.org] OpenFOAM Cluster Setup for Beginners	Ruli	OpenFOAM Installation	7	July 22, 2016 04:14
[ICEM] surface/curve mesh setup	Studi	ANSYS Meshing & Geometry	15	November 12, 2014 00:32
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 00:27

All times are GMT -4. The time now is 00:05.