|
[Sponsors] |
November 9, 2016, 15:15 |
setup ejector unit in helyx os
|
#1 |
New Member
Join Date: Oct 2016
Posts: 1
Rep Power: 0 |
Hello everyone,
As my nick says I am an openfoam beginner. My first problem is how to setup ejector unit in helyx os correctly, here is the picture from the "air". I made for main Inlet total pressure (for example for 8bar, 801325/1.205=665000 m2/s2) and for the rest total pressure 0 and velocity type for all input pressure inlet outlet velocity, turbulence model - k- omega SST. Then I made analysis but the result are about (1/5)-(1/10) of real results. Any suggestions? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Taylor Couette Setup and Boundary Conditions | DaSh | OpenFOAM Pre-Processing | 2 | September 28, 2017 12:02 |
2D Glass Melt Simulation Setup | marmz | FLUENT | 5 | October 9, 2016 15:25 |
[OpenFOAM.org] OpenFOAM Cluster Setup for Beginners | Ruli | OpenFOAM Installation | 7 | July 22, 2016 04:14 |
[ICEM] surface/curve mesh setup | Studi | ANSYS Meshing & Geometry | 15 | November 12, 2014 00:32 |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |