|
[Sponsors] |
June 5, 2017, 09:51 |
create cellZones for external aerodynamic
|
#1 |
Member
Join Date: May 2017
Posts: 38
Rep Power: 9 |
Hello everybody,
I work on an external aerodynamic case with openFoam. I constructed my case like motorbike tutorial, I have a .stl file with one element. I created a domain with blockMesh, and after I included the stl and refined my mesh with snappyHexmesh. After this first step, I ran my case with simpleFoam, next with pimpleFoam and know I would like to run my case with pimpleDyMFoam. In dynamicMeshDict I chose solidBodyMotionFvMesh with oscillatingRotatingMotion. To run my case I need a cellZone. My problem is here. I created a cellzone with toposet but all the domain was rotating and not only the stl. After I tried to create cellzones with snappyHexMesh but I don't understand how it works. So my question is: do someone knows how to create a cellzone to move only my stl and not all domain? Thanks in advance for your help. |
|
Tags |
cellzones, external aerodynamic, openfoam, pimpledymfoam |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
create the file *.foam | phongstar | OpenFOAM | 12 | October 14, 2018 19:06 |
[ICEM] how to create a 2d tri mesh with quad mesh in the boundary layer | seal2013 | ANSYS Meshing & Geometry | 3 | October 6, 2013 17:09 |
Cannot create cellZones with Snappy | donQi | OpenFOAM Pre-Processing | 2 | August 14, 2013 04:04 |
DecomposePar and CellZones | Anne Lincke | OpenFOAM | 4 | October 13, 2010 10:18 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 08:06 |