|
[Sponsors] |
Boundary Conditions for ke model - flow over flat plate |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 24, 2018, 02:09 |
Boundary Conditions for ke model - flow over flat plate
|
#1 |
New Member
Ben
Join Date: Oct 2016
Posts: 25
Rep Power: 9 |
Hi everyone, I am trying to simulate a 2D flow over a flat plate (adapted from the lid-driven cavity case) where I have an inlet, outlet, top and bottom walls, and empty frontAndBack.
The objective of my case is to plot u+ vs y+ to see how well captured my wall grid is. I'm using the komegaSST turbulence model. Thing is, most, if not all of the tutorials use wall functions (kqRWallFunction, nutkWallFunction, omegaWallFunction) for the wall patches of their cases. For me, what should be boundary conditions be if I have a grid fine enough (y+~0.4) to capture the wall? I have tried the calculated BC but my case would not run well and diverges. Please see the attached for my case files. I think it's a simple problem but somehow I cannot get this right. I have tried the calculated and fixed value conditions for k and e but the solution diverges. By the way, this is a transient case using pisoFoam, on OpenFOAMv1706. Please see the attached files for my current case that has wallfunctions implemented. Thank you for your time. Last edited by bentkj; May 24, 2018 at 03:36. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Velocity vector in impeller passage | ngoc_tran_bao | CFX | 24 | May 3, 2016 21:16 |
Low torque values on Screw Turbine | Shaun Waters | CFX | 34 | July 23, 2015 08:16 |
Setting rotating frame of referece. | RPFigueiredo | CFX | 3 | October 28, 2014 04:59 |
Overflow Error in Multiphase Modelling with Two Continuous Fluids | ashtonJ | CFX | 6 | August 11, 2014 14:32 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |