|
[Sponsors] |
July 16, 2020, 13:15 |
Ramping the total pressure boundary?
|
#1 |
Member
Join Date: Jun 2011
Location: Germany
Posts: 59
Rep Power: 14 |
Hello,
is it possible to ramp the totalPressure boundary over time like the uniformFixedValue with table? Thanks a lot. |
|
July 17, 2020, 13:31 |
|
#2 |
Senior Member
Hrvoje Jasak
Join Date: Mar 2009
Location: London, England
Posts: 1,905
Rep Power: 33 |
Then a may be a function like this - not sure. Look for a version that will take an expression for p0.
However, don’t expect miracles - I have been tempted to try this a few times and it never did anything for me. Your problem is probably somewhere else. Hrv
__________________
Hrvoje Jasak Providing commercial FOAM/OpenFOAM and CFD Consulting: http://wikki.co.uk |
|
July 25, 2020, 21:44 |
|
#3 |
Senior Member
Fumiya Nozaki
Join Date: Jun 2010
Location: Yokohama, Japan
Posts: 266
Blog Entries: 1
Rep Power: 18 |
There is uniformTotalPressure boundary condition.
You might want to check the tutorial: incompressible/pimpleFoam/RAS/TJunction Hope this helps, Fumiya
__________________
[Personal]
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
static vs. total pressure | auf dem feld | FLUENT | 17 | February 26, 2016 13:04 |
Wrong flow in ratating domain problem | Sanyo | CFX | 17 | August 15, 2015 06:20 |
Low torque values on Screw Turbine | Shaun Waters | CFX | 34 | July 23, 2015 08:16 |
Difficulty In Setting Boundary Conditions | Moinul Haque | CFX | 4 | November 25, 2014 17:30 |
An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |