|
[Sponsors] |
May 24, 2023, 04:34 |
pressure boundary condition for inlet-outlet
|
#1 |
New Member
Join Date: Sep 2022
Posts: 8
Rep Power: 3 |
I'm running a simulation with a cylinder domain where the curved wall acts as inlet-outlet depending on the direction of the flow. I'm using simplefoam with atmBoundaryInletVelocity in the inlet-outlet U to simulate an ABL.
I have a problem when defining the pressure boundary condition for the inlet-outlet as a freestreampressure boundary. When i use this boundary condition simplefoam exits returning a non-zero exit code. i tried setting the boundary of inlet-outlet to fixedValue and it works fine with that, but I believe this boundary is incorrect. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about different kinds of Boundaries and Boundary Conditions | granzer | Main CFD Forum | 17 | April 12, 2022 17:27 |
Wind tunnel flow simulation boundary condition issue | charan3007 | SU2 | 0 | October 21, 2021 08:27 |
Fail to converge when solving with a fabricated solution | zizhou | FLUENT | 0 | March 22, 2021 06:33 |
Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 17:38 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |