 |
 |
 |
|
|
|
[Sponsors] | ||||
restart a simulation from latestTime but now with combustion |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 10, 2023, 20:12
|
restart a simulation from latestTime but now with combustion
|
#1 |
|
New Member
Edoardo
Join Date: Apr 2023
Location: Italy
Posts: 27
Rep Power: 3  |
Hello, I would like to simulate a flammable gas flow not ignited, then stop the simulation and restart with combustion. Is it possible to do a 2-step simulation (resuming through latestTime in controlDict)?
If I change the constant properties like chemistryProperties and combustionProperties, does the simulation restart without errors? If anynone has already been through this and wants to share their knowledge, I thank you very much for the help. |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Combustion Simulation ANSYS Fluent - There is no ignition delay | Rudolf Diesel | FLUENT | 1 | May 21, 2023 07:30 |
| Combustion Simulation ANSYS Fluent - There is no ignition delay | Rudolf Diesel | FLUENT | 2 | October 1, 2018 02:16 |
| PIMPLE not converging after simulation restart | pawlo | OpenFOAM Running, Solving & CFD | 1 | December 4, 2017 17:08 |
| Mesh used for Combustion Simulation | Stein | CFX | 5 | May 14, 2009 19:24 |
| Help me for the simulation on hydrogen/air combustion | xulixian | CFX | 1 | April 16, 2009 16:57 |
Linear Mode
