|
[Sponsors] |
September 20, 2006, 01:58 |
Hi,
at first sorry for my b
|
#1 |
Guest
Posts: n/a
|
Hi,
at first sorry for my bad english... However, I want to use OpenFOAM for simulation. I am engineer for HVAC and I am to interesset in simulation for airflows in building rooms but my experiment crashed in OpenFOAM everytime :-( I make a room with one block and every side is a wall function. Furthermore I make two blocks on the side of a wall. One block is for the inlet slot and the other for the outlet slot. My question is: When I make the block for inlet slot I am defining one patch of the block as the inlet patch and the other 5 side are walls? If am not defining the other side, the simulation stops because of "empty patches". Maybe can somebody give me excample for simulation inlet slot in 3D rooms? It whould help me. Thanks Myting |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Floworks for simulation of airflow in large rooms. | kajaken | FloEFD, FloWorks & FloTHERM | 1 | October 28, 2008 13:58 |
Slot jet impinging on cylinder | Diz | CFX | 0 | September 24, 2007 21:34 |
Slot jet in cross flow. | Hamdy | Phoenics | 0 | March 5, 2006 04:01 |
impinging slot-jet | ramesh.... | FLUENT | 1 | April 6, 2005 10:35 |
How to do turbulent bc on the injection slot? | peter.zhao | Main CFD Forum | 3 | June 26, 2004 07:05 |