[impecca]

Dear foamers

I tried to set up a pitching airfoil case based on the propeller tutorial in OF v2.1.0. But a few points in the stationary part of domain follow the rotating domain. please see the red circle in the attached figure. Is there anyone who knows how to fix this?

The procedures which I followed are
- mesh generation in Gridgen (set 'insideSlider', 'outsideSlider' separately in BC sets)
- output as a fluent case file
- convert to into OF files using fluentMeshToFoam
- set up 'boudary' file for AMI (attachment, 'boundary.txt')
- set rotating cellzone by using 'setSet' -> cellSet insideZone new cylinderToCell (0.5 0 0) (0.5 0 0) 2.5 (see 'dynamicMeshDict.txt')
- setsToZone -noFlipMap
- run.

Regards
Yusik