file here not here???

Bdew8556 · November 8, 2019, 00:24

Hi all,

Anyone have any thoughts on this? No idea whats going on...

raumpolizei · November 8, 2019, 05:44

Hey,
Could be related to file ownership, try "ls -l" in your application folder (and "ls -l Make") to check that you are indeed allowed to read all files or directories. If not so, you will need to change the ownership or the rights (chmod or chown) for these files (you may need root permissions to do so). Good luck!
Cheers RP

Bdew8556 · November 10, 2019, 19:54

Thanks for that.

I get this response. Any thoughts??

einstein_zee · November 11, 2019, 05:16

Hey,

As "raumpolizei" stated you have no control over those files. You may notice that when you type "ls -al" on the left you see a series of "rwx" letters for each file and directory. You need at least the first three to be able to read, write and execute for any file. look at https://en.wikipedia.org/wiki/Chmod to get an idea about the topic.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to calculate mass flow rate on patches and summation of that during the run?	immortality	OpenFOAM Post-Processing	104	February 16, 2021 08:46
[foam-extend.org] problem when installing foam-extend-1.6	Thomas pan	OpenFOAM Installation	7	September 9, 2015 21:53
[swak4Foam] Problem installing swak_2.x for OpenFoam-2.4.0	towanda	OpenFOAM Community Contributions	6	September 5, 2015 21:03
"parabolicVelocity" in OpenFoam 2.1.0 ?	sawyer86	OpenFOAM Running, Solving & CFD	21	February 7, 2012 11:44
ParaView Compilation	jakaranda	OpenFOAM Installation	3	October 27, 2008 11:46

November 8, 2019, 05:44		#2
raumpolizei Member Join Date: Dec 2018 Location: Darmstadt, Germany Posts: 87 Rep Power: 7	Hey, Could be related to file ownership, try "ls -l" in your application folder (and "ls -l Make") to check that you are indeed allowed to read all files or directories. If not so, you will need to change the ownership or the rights (chmod or chown) for these files (you may need root permissions to do so). Good luck! Cheers RP

November 11, 2019, 05:16		#4
einstein_zee Member Hosein Join Date: Nov 2011 Location: Germany Posts: 93 Rep Power: 14	Hey, As "raumpolizei" stated you have no control over those files. You may notice that when you type "ls -al" on the left you see a series of "rwx" letters for each file and directory. You need at least the first three to be able to read, write and execute for any file. look at https://en.wikipedia.org/wiki/Chmod to get an idea about the topic.