|
[Sponsors] |
September 27, 2018, 00:20 |
wmake error: command not found
|
#1 |
New Member
Ishan Anjikar
Join Date: Mar 2018
Posts: 21
Rep Power: 8 |
Hi
I am trying to make a new solver and followed the steps mentioned here: https://www.cfdsupport.com/OpenFOAM-...t/node187.html The folder mentioned in the $WM_PROJECT_USER_DIR was not present initially, so i made the folder. I have attached the sequence of commands i used. I am getting the error for wmake command. I have tried to compile on OpenFOAM-v1706, OpenFOAM-v1712 and OpenFOAM-1806 Please help me solve this error. If i am doing something wrong, please guide me on how to correct it. Thank you. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Building OpenFOAM1.7.0 from source | ata | OpenFOAM Installation | 46 | March 6, 2022 13:21 |
error in fireFoam, when running the case wallFireSpread2D | zhoubiao1088 | OpenFOAM Running, Solving & CFD | 9 | February 1, 2018 18:45 |
Gmsh installation on terminal help | spitfire | Main CFD Forum | 4 | July 27, 2017 15:11 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |