 |
 |
 |
|
|
|
[Sponsors] | ||||
March 4, 2019, 21:17
|
Out of temperature range in JanafThermo
|
#1 |
|
Senior Member
LT
Join Date: Dec 2010
Posts: 104
Rep Power: 15  |
Hi, everyone,
A warning message "JanafThermo<EquationOfState> out of temperature range 216.37-400, T=xxx" appears repeatedly, where xxx means a temperature over 400K while calculating a supersonic flow case. Though it dose not stop the calculation and set the highest temperature 400K, how to get rid of this message? Thanks in advance! |
|
|
|
|
| Tags |
| janafthermo, temperature range |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| heat transfer coefficient value in floefd | jason kid | FloEFD, FloWorks & FloTHERM | 10 | October 16, 2016 16:55 |
| DieselFoam and temperature out of janaf range | hoogland | OpenFOAM Running, Solving & CFD | 5 | January 28, 2016 12:30 |
| 2 region with varied properties | guserik | OpenFOAM Running, Solving & CFD | 0 | January 11, 2014 14:58 |
| Free stream temperature | saharesobh | FLUENT | 1 | October 11, 2012 20:52 |
| How to get free stream temperature in boundary condition | saharesobh | FLUENT | 0 | October 9, 2012 17:12 |
Threaded Mode
