|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Sihang Gao
Join Date: Jun 2020
Posts: 1
Rep Power: 0 ![]() |
Hi, foamers.
I'm a beginner in OpenFOAM and I'm trying to simulate droplet impact cases on superhydrophobic surface using immersed boundary method(interIbFoam solver in foam-extend 4.0). I run the tutorial in foam-extend but it seems that the constantalphacontactangle bc is unavailable for the immersed boundary. I have read some paper about contact angle model in IBM but have no idea about how to apply this in OpenFOAM. Is there any instruction about coupling these two boundary conditions? With regards and thanks in advance! |
|
![]() |
![]() |
![]() |
Tags |
contact angle, immersed boundary method |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic contact angle issue: fluent UDF couldn't set the correct contact angle | FelixJJ | FLUENT | 2 | October 20, 2021 02:39 |
[swak4Foam] swakExpression not writing to log | alexfells | OpenFOAM Community Contributions | 3 | March 16, 2020 18:19 |
inaccurate contact angle capturing in high shear/viscousity flow | chery1986 | OpenFOAM Running, Solving & CFD | 0 | October 23, 2015 00:14 |
Dynamic contact angle | raj kumar saini | Fluent UDF and Scheme Programming | 0 | October 13, 2014 02:18 |
dynamic contact angle / contact line velocity | ThomasN | CFX | 6 | September 23, 2014 06:07 |