|
[Sponsors] |
May 7, 2023, 23:03 |
How to access all the processors in wsl
|
#1 |
New Member
Parth
Join Date: Feb 2021
Posts: 14
Rep Power: 5 |
I am using Hp Z6 G4 workstation. It have two processors each with 20 physical cores in it but the lscpu on wsl only detects the one processor, due to which i am not able to fully utilize all the physical cores of system.
I am getting this on lscpu postanddelete.jpg PLEASE HELP I am expecting a code or steps to configure wsl so it can access all the processors in my workstation |
|
Tags |
wsl |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
parallel run in foam extend | CRI_CFD | OpenFOAM CC Toolkits for Fluid-Structure Interaction | 5 | March 28, 2024 09:36 |
Get list of shared points by neighbor processors with same order | andpush | OpenFOAM Programming & Development | 0 | June 18, 2019 05:19 |
Socket 2011-3 processors - an overwiew | flotus1 | Hardware | 10 | June 17, 2017 10:47 |
Is there a way to access the gradient limiter in Fluent ? | CFDYourself | FLUENT | 1 | February 16, 2016 06:49 |
64-bit processors for home computing | Ananda Himansu | Main CFD Forum | 2 | March 16, 2004 13:48 |