|
[Sponsors] |
March 19, 2013, 11:39 |
parcels too small?
|
#1 | |
Member
Adam
Join Date: Jun 2011
Posts: 32
Rep Power: 14 |
I'm using the sprayFoam solver in OF 2.1.1 to inject liquid water in a small steam space. If I set the parcel diameter at 0.001 m, the solution converges without problems. If I start to decrease the diameter (10^-6 or less), I begin to get warnings and my results become junk.
Quote:
|
||
March 19, 2013, 12:32 |
|
#2 |
Member
ri
Join Date: Oct 2012
Posts: 34
Rep Power: 13 |
Hello,
You might have to edit some of the constant properties in the sprayCloudProperties file namely: minParticlemass rhoMin regards, ris. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] .STL: non-closed manifold surface | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 32 | November 25, 2016 03:15 |
why did Time step is too small in stiffbs? | satum | FLUENT | 1 | December 10, 2012 09:15 |
Simulating small features on large models | siw | CFX | 1 | February 16, 2012 17:10 |
Small influence of convection in PISO if Courant number is small | sebi | OpenFOAM | 0 | February 22, 2011 14:55 |
what happens if y+ is too large or too small | Bo Jensen | Siemens | 12 | February 19, 2003 23:31 |