|August 26, 2013, 09:37||
AMI - Propeller Tutorial diverging
Join Date: May 2013
Location: Munich Germany
Posts: 29Rep Power: 5
I am trying to learn how to implement AMI with the help of pimpleDyMFoam tutorial of propeller. when I start the simulation using Allrun command the simulation blows up after ~35 iterations. the continuity suddenly becomes from 0.1 to 1e+3 and then the simulation diverges. I have not done any changes to the tutorial provided with the distribution (I am using OF 2.1.1).
I am quite confused why that is happening. Any suggestions what should be done ?
Also I want to implement AMI with MRFSimpleFoam. Do we need constant/dynamicMeshDict ... ? Also what else will be the major changes when compared to the tutorial of propeller. Because tutorial is a transient simulation with pimpleDyMFoam where as I want to do steady state simulation.
Any help/suggestions will be greatly helpful and will be appreciated.
Thanks in Advance.
|November 4, 2016, 03:57||
Join Date: Aug 2015
Location: Busan, South Korea
Posts: 27Rep Power: 3
In MRF we don't use the dynamicsMeshDict, but we need MRFProperties, it's different scripts. then you have to change some scripts.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Propeller case in AMI tutorial||reza1980||OpenFOAM Running, Solving & CFD||67||April 28, 2017 05:22|
|propeller tutorial using AMI in OF v2.1.0||impecca||OpenFOAM Pre-Processing||6||May 9, 2016 10:22|
|Run A propeller case with AMI and not accelerated flow behind the blades...||reza1980||OpenFOAM||6||September 11, 2013 03:09|
|mixerVesselAMI2D's mass is not balancing||sharonyue||OpenFOAM Running, Solving & CFD||6||June 10, 2013 09:34|
|AMI speed performance||danny123||OpenFOAM||19||October 24, 2012 07:44|