|
[Sponsors] |
August 22, 2018, 10:32 |
Water jet in submerged condition
|
#1 |
New Member
Livia Adinolfi
Join Date: May 2017
Posts: 15
Rep Power: 8 |
Dear Foamers,
I have not used OpenFoam for ages and I was not an expert before. So I am asking for help. I have checked if there are similar problems, but I could not find anything. I need to simulate a water jet, impinging vertically on a soil sample (which I can model as a soild) in a tank full of water. I was wondering which is the best solver for this problem ? I have tried pimpleFoam, since the JET is submerged. But I have an interface air/water in the tank (quite far from the stagnation point) and I do not know if I should consider it. In this case should I use interFoam? Thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No liquid water exist in my Fuel Cell simulation | fatchang | FLUENT | 19 | October 15, 2018 14:27 |
Water jet propulsion | shashi | FLUENT | 1 | October 1, 2008 06:11 |
Simulating air jet into 2D & 3D water domain | Imran | FLUENT | 0 | June 6, 2006 08:57 |
Impinging Jet. Outlet Boundary Condition | Vincent | Main CFD Forum | 0 | December 16, 2003 10:49 |
Help!!!problems in air jet into water bath | kim | FLUENT | 4 | June 9, 2003 07:04 |