 |
 |
 |
|
|
|
[Sponsors] | ||||
August 6, 2014, 10:21
|
|
#5 |
|
Member
Ali
Join Date: Oct 2013
Location: St John's Canada
Posts: 31
Rep Power: 12  |
Hi,
Good morning. I am trying to simulate the same case as Mike, one propeller blade with cyclic boundary at the two sides using SRFSimpleFoam. After few iterations the time step continuity error become high and stops the simulation with error message. I couldn't understand the reason behind it. I am trying solve it from the last two weeks. But no progress. I think I have messed up the boundary conditions and solver settings. Would you please help me providing hints / advice. Any kind of help is appreciated. Ali |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Simulation flow through Propeller by SRFSimpleFoam | baoaero | OpenFOAM Running, Solving & CFD | 14 | July 5, 2021 11:44 |
| [ICEM] Blocking of impeller single blade sector (MRF) | delaneyluke | ANSYS Meshing & Geometry | 1 | May 6, 2011 09:28 |
| 360 degree fluid zone for a 4 blade propeller | s0me0ne | CFX | 5 | June 27, 2010 07:09 |
| propeller blade meshing | Terence | Fidelity CFD | 8 | July 15, 2008 13:31 |
| Blade thickness on propeller wash prediction | Lam | Main CFD Forum | 1 | October 28, 2005 02:36 |
Threaded Mode
